Pool Cage Rescreening in Fort Myers
We replace torn, bowed and sun-brittled pool cage screens for homeowners throughout Fort Myers, matching mesh type and frame condition to local sun and storm exposure.
- Free Written Estimate
- Fast Scheduling
- Built for Florida Weather
- Licensed & Insured
- BBB A+ Rated
- 150,000+ Customers Served
- 283+ 5-Star Reviews
Request Your Free Estimate
Tell us about your screens and we will send a free estimate.
- Free No-Obligation Estimate
- Fast Response Times
- No Pressure Consultation
Fort Myers pool cages face a particular combination of stress: intense UV exposure nearly year-round, salt-laden air drifting in from the Gulf and Caloosahatchee, and the wind-driven rain of summer storm season. Screen mesh typically shows its age first, turning brittle, discoloring, or tearing loose from the spline channel, while the aluminum frame can hold up much longer if it was properly painted and maintained.
We have worked on cages across Fort Myers, from older lanais in established neighborhoods near the river to newer enclosures in communities off Daniels Parkway and Six Mile Cypress. Our rescreening work addresses torn panels, loose spline, sagging door screens, and full lanai rescreens, using mesh selected for the home’s sun exposure and the owner’s preference for visibility, pet resistance, or storm durability.
Sun and Salt Air Across Fort Myers Neighborhoods
Homes along the Caloosahatchee River and canal-front properties near Cape Coral tend to show screen wear faster, since salt carried on the breeze settles into the mesh and accelerates oxidation at the spline track. Lanai screen repair in Fort Myers often starts with these waterfront enclosures, where fasteners and screws corrode well before the frame itself shows any trouble.
Further inland, around Lehigh Acres, the bigger factor is UV load rather than salt. Screens there tend to go brittle and crack from sustained sun exposure rather than corrode, so the failure pattern looks different even though the end result, torn or sagging panels, is the same. Bonita Springs properties close to the coast often see both issues at once.
Because wear patterns vary by location, we look at where a cage sits, not just its age, when recommending mesh and fastening hardware for a screen repair in Fort Myers, FL. A cage three blocks from saltwater needs different attention than one in a dry, sun-heavy interior neighborhood.
How We Rescreen a Lanai, Step by Step
We start with a full walk-around of the enclosure, measuring each panel and checking the frame for bent members, loose fasteners, or corrosion at the joints before any old screen comes off. This inspection determines whether the project is a straightforward rescreen or whether frame repair needs to happen first. We note door hardware and any custom panel shapes at this stage as well.
Old mesh and spline are removed panel by panel, and the frame channel is cleaned out so the new spline seats properly. We check each frame member again once it is bare, since corrosion and hairline cracks are easier to spot without screen covering them. New mesh is cut, rolled into the channel with fresh spline, and trimmed for a tight, even fit.
Once every panel is set, we walk the cage again to check tension and look for gaps at corners or door frames, then clear away old screen scraps and spline debris before leaving the site. Homeowners in HOA communities sometimes need mesh color or type approved in advance, and we can work from those guidelines when a rescreen is scheduled.
- Inspection and measurement of each screen panel
- Removal of old mesh and spline, frame checked for corrosion or bends
- Mesh selection based on sun exposure, salt proximity, and HOA rules
- Installation with new spline and panel-by-panel tensioning
- Site cleanup and final check of fit and corners
Scheduling, Access, and HOA Approval
Most lanai screen repair jobs in Fort Myers run from a half day for a handful of panels to two or three days for a full rescreen, depending on cage size and panel count. We ask for clear access to the pool deck and surrounding yard, since ladders and panel material need room on at least one side of the enclosure.
Summer afternoon storms are routine in Lee County, and we schedule around them rather than screening in active rain or high wind, since wet spline and mesh will not seat properly in the frame channel. If your community in Fort Myers or nearby Bonita Springs requires architectural review for screen color or mesh type, we can work from your HOA’s approved specifications before ordering material.
Why Mesh Choice and Prep Work Matter
A common mistake we see on older enclosures is rescreening over a frame that is already corroded, bent, or pulling away from its fasteners. New mesh stretched over a compromised frame will sag or tear again within a season, so we check every panel track and corner key before installing anything.
Mesh choice matters as much as installation. Standard fiberglass screen works for most Fort Myers homes, but pet owners and properties exposed to wind-driven debris near Lehigh Acres or open water often do better with heavier pet-resistant or storm-rated mesh. We walk through these options during the estimate so the material matches how the lanai is actually used.
Process and Timeline
- We inspect the full cage, documenting frame condition, panel count, and any areas of existing damage.
- We review mesh options with you, including standard, pet-resistant, and storm-rated screen, and note any HOA material requirements.
- We remove the old screen and spline, then clean out the panel channels before fitting new material.
- We stretch and spline each panel in place, trimming excess and checking tension by hand.
- We walk the completed enclosure with you to confirm fit and finish before closing out the job.
Most rescreening projects in Fort Myers are completed within one to three days, depending on cage size, panel count, and weather conditions.
Fort Myers Pool Cage Rescreening FAQ
How long does pool cage rescreening take in Fort Myers?
Most lanai rescreening projects take one to three days depending on the size of the cage and the number of panels involved. Larger enclosures or those with custom panel shapes around a pool cage roof line can take longer, and the crew will give you a realistic window after the on-site walkthrough.
What mesh type holds up best against Fort Myers sun and storms?
Fiberglass screen is common and affordable, but in Lee County's intense UV exposure, many homeowners choose a heavier charcoal or black fiberglass mesh, or upgrade to a stronger pet-resistant or storm-rated screen for panels that face open yards or canals. The right choice depends on sun exposure, whether you have pets, and how much wind-driven rain the cage typically takes on.
Can you rescreen just a few damaged panels instead of the whole cage?
Yes, spot rescreening of individual torn or sagging panels is routine work, and it does not require redoing the entire enclosure. The tradeoff is that newly installed screen can look slightly different in tone from older, sun-faded panels nearby, which is worth considering if the whole cage is approaching the same age.
Will my HOA require approval before rescreening my lanai?
Many communities in and around Fort Myers do require a submission or at least notice before exterior screen work, particularly if the mesh color or panel pattern will change. It is worth checking your HOA's architectural guidelines first, and the crew can provide photos or spec sheets if your association asks for documentation.
Do I need to drain or cover my pool during the rescreening work?
No draining is necessary, and the pool typically stays usable during the project since the work happens on the screen panels and frame, not in the water. The crew will lay down drop cloths or protective covering near the pool edge to keep debris and old screen material out of the water.
How do I know if I need rescreening or if the frame itself needs repair?
Torn, sagging, or UV-brittle screen with an otherwise straight, solid aluminum frame usually just needs rescreening. But if panels are bowing, fasteners are pulling loose, or you see rust streaks and corrosion at the joints, that points to frame damage that should be addressed before new screen goes in, otherwise the new mesh will fail again quickly.
More Pool Cage Services in Fort Myers
If the aluminum frame itself is chalky, faded, or rusting, Fort Myers homeowners can also ask about having the cage painted alongside or instead of rescreening. Pool Cage Painting.
Nearby Areas We Also Serve
Crews based in Fort Myers also take on rescreening and cage work in the surrounding Lee County communities. Cape Coral, Bradenton, Sarasota, Tampa, Naples and Venice.
Statewide details, colors and the full process are on our main pool cage rescreening page.
Recent Work
Request a Fort Myers Rescreening Estimate
Send a few photos of the damaged or worn panels along with your Fort Myers address through the form, or call (941) 320-2858 to describe the cage over the phone. Either way, you will receive a written estimate with no obligation before any work is scheduled.
Last reviewed: October 17, 2026